24-Port 10/100Mbps+2 Gigabit TP/SFP Combo Managed PoE Switch - 380W, 2yr
We usually stock at least a couple units. Larger orders can take 10-14 days to ship. Stock changes daily.
Features:
24 10/100Mbps Fast Ethernet ports with PoE Injector function
• 2 10/100/1000Mbps TP and 1000Mpbs SFP shared combo interfaces
• Reset button for system management
• 1 RS-232 male DB9 console interface for basic Switch management and setup
Power over Ethernet
• Complies with IEEE 802.3af Power over Ethernet End-Span PSE
• Provides 380 Watts power to maximum 24 IEEE 802.3af devices
• Supports PoE Power up to 15.4 Watts for each PoE port
• Auto detect powered device (PD)
• Circuit protection prevents power interference between each port
• Remote power feeding up to 100m
• PoE Management
–Total PoE power budget control
–Per port PoE function enable/disable
–PoE Port Power feeding priority
–Per PoE port power limit
–PD classification detection
Specification:
Hardware Specification | |
10/100Mbps Copper Ports | 24 10/100Base-TX RJ-45 Auto-MDI / MDI-X ports |
1000Mbps Copper Ports | 2 10/100/1000Mbps RJ-45 Auto-MDI / MDI-X ports |
SFP / mini-GBIC Slots | 2 1000Base-SX/LX/BX, shared with Port-25~Port-26 |
Switch Architecture | Store-and-Forward |
Switch Fabric | 8.8Gbps / non-blocking |
Switch Throughput | 6.547Mpps @64Bytes |
Address Table | 8K entries |
Share Data Buffer | 512Kbytes |
Maximum Frame Size | 9K Bytes |
Flow Control | Back pressure for Half-Duplex IEEE 802.3x Pause Frame for Full-Duplex |
LED | Power, FAN Alarm Link / Activity (Green) PoE In-Use (Amber) 1000 LNK / ACT(Green) 10/100 LNK / ACT(Green) |
Dimension (W x D x H) | 440 x 300 x 44 mm, 1U height |
Weight | 4.2kg |
Reset Button | < 5 secs: System reboot > 10 secs: Factory Default |
Power Input | 100 ~ 240VAC, 50 / 60Hz, Auto-sensing |
Power Consumption | 400 Watts / 1372.4 BTU |
Power over Ethernet | |
PoE Standard | IEEE 802.3af Power over Ethernet / PSE |
PoE Power Supply Type | End-Span |
Power Pin Assignment | 1/2(+), 3/6(-) |
PoE Power Output | Per Port 48V DC, 350mA . Max. 15.4 Watts |
PoE Power Budget | 380 Watts |
Max. number of Class 2 PD | 24 |
Max. number of Class 3 PD | 24 |
Layer 2 Function | |
Management Interface | Console, Telnet, Web Browser, SSL, SNMPv1, v2c |
Port Configuration | Port disable / enable Auto negotiation 10/100/1000Mbps full and half duplex mode selection Flow Control disable / enable |
Port Status | Display each port’s speed duplex mode, link status and Flow control status Auto negotiation status, trunk status |
Port Mirroring | TX / RX / Both 1 to 1 monitor |
Bandwidth Control | Ingress / Egress Rate Control Allow to configure per 128Kbps |
VLAN | IEEE 802.1Q Tag-based VLAN Port-based VLAN Q-in-Q tunneling Up to 255 VLANs groups, out of 4041 VLAN IDs |
Link Aggregation | Supports 13 groups of 8-Port trunk, IEEE 802.3ad LACP |
QoS | Traffic classification based on Port priority, 802.1p priority, DSCP / TOS field in IP Packet |
IGMP Snooping | IGMP (v1/v2) Snooping, up to 256 multicast groups |
Access Control List | IP-Based ACL / MAC-Based ACL Up to 220 ACL rule entries |
SNMP MIBs | RFC-1213 MIB-II RFC-2863 Interface MIB RFC-2665 EtherLike MIB RFC-1493 Bridge MIB RFC-2819 RMON MIB (Group 1, 2, 3,9) RFC-2737 Entity MIB Power-over-Ethernet-MIB |
Standards Conformance | |
Regulation Compliance | FCC Part 15 Class A, CE |
Safety | UL, cUL |
Standards Compliance | IEEE 802.3:10Base-T IEEE 802.3u:100Base-TX IEEE 802.3z:1000Base- SX/LX IEEE 802.3ab:1000Base-T IEEE 802.3x:Flow Control and Back Pressure IEEE 802.3ad:Port trunk with LACP IEEE 802.1D:Spanning Tree Protocol IEEE 802.1w:Rapid Spanning Tree Protocol IEEE 802.1p:Class of Service IEEE 802.1Q:VLAN Tagging IEEE 802.1x:Port Authentication Network Control RFC 768:UDP RFC 793:TFTP RFC 791:IP RFC 792:ICMP RFC 2068:HTTP RFC 1112:IGMP version 1 RFC 2236:IGMP version 2 |
Environment | |
Operating | Temperature: 0 ~ 50 Degree C Relative Humidity: 20 ~ 95% (non-condensing) |
Storage | Temperature: -10 ~ 85 Degree C Relative Humidity: 20 ~ 95% (non-condensing) |
Downloads: